more stuff! driveshaft/strut housings/mt1 wheel

[dirtbag30]

bimmerworld fog light deletes dirty but undamaged $25 plus shipping



mtechI wheel in fair condition. some stitching is loose $150 shipped
more photos upon request.



a bit ugly but perfectly useable, mechanically good driveshaft.
from 96 e36 m3. 6 bolt flange. fits zf trans
will work with 24v swap with zf trans. $350 plus shipping.



51 mm strut housings with coilover perches welded on. good for a coilover project. $90 plus shipping.

[amiller07]

Driveshaft will not work with e30 diff unless you get a 4 bolt rear half


Sent from my iPhone using Tapatalk

[dirtbag30]

Driveshaft will not work with e30 diff unless you get a 4 bolt rear half


Sent from my iPhone using Tapatalk

correct.

[ForcedFirebird]

Driveshaft will not work with e30 diff unless you get a 4 bolt rear half


Sent from my iPhone using Tapatalk

e36 shafts are more difficult to mix and match with the both universal being attached to the rear half. The e30 shaft has a universal on the end of each half making them easy to realign. The e36 has both on one half. This means you ave to phase the 3 prong yoke with correct geometry to a "4 prong" universal joint.

[dirtbag30]

correction. to get this to fit in an e30, with 24v and zf trans you need the 6 bolt flange seen here as well
i should have been more specific.
its easy to change, how ive been running it in my car for the past three years.

[ForcedFirebird]

^^^ Yup. Even the ZF trans can swap yokes with getrag, just have to modify the nut a little to fit in the center.

[dirtbag30]

Bump. Buy these.

[fight4life28]

Shorten strut housing? thanks

[dirtbag30]

Shorten strut housing? thanks

No these are just stock length with perches welded on.

[dirtbag30]

bump

[dirtbag30]

bump. more parts added. help fund my bike addiction. i have alot of parts if you need something specific let me know. ill sell anything for the right price