new C101 conector pins w/ 14" of wire.

[george graves]

These are the uber expensive new pins to re-wire your c101 conector for motor swaps. I bought these to swap a few of the pins and re-map them, but ended up going another route.

I forget what I paid for these, but it was $$$.

I have 7 in all. $25 shipped

[JGood]

So what exactly do you do, cut the old ones off and crimp these on? Why can't you re-use the old ones? Do you need a special tool to attach them or anything?

And do you happen to know off hand how many pins are in a c-101?

[george graves]

So what exactly do you do, cut the old ones off and crimp these on? Why can't you re-use the old ones? Do you need a special tool to attach them or anything?

And do you happen to know off hand how many pins are in a c-101?

Generally, you'll break the locking taps on the pins when you remove them. These are new, with the locking tabs ready to snap into place. Remove old pins (one method is to yank them out, another is to use something to force them out), then these new pins slide in, and with a small amount of force, snap in and lock in place just like factory.

Not sure how many pins are in a c101

[mazur]

The pins cost $1.80+/- each from the dealer.

Are the pins attached to wire? If they are can you post some pics?

C101 takes 20 pins, BTW.

[James Crivellone]

The pins cost $1.80+/- each from the dealer.

Are the pins attached to wire? If they are can you post some pics?

C101 takes 20 pins, BTW.

Depends on the year, 88 - 91 C101 uses ~20

86 - 87 C101 use less

[LINUS]

M3's only used like 13-14.

Are these the male or female end, or some of each?

[george graves]

Male "pin" (think penis, not vigina)..With wire attached.

From my dealer they were ALOT more then $2!!! I think I paid around $5/each.

Oh, well - Price as is *OBO*