If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I picked up one of these from another member on here. Also purchased a bored throttle body from him too. I've recently purchased a myster-e head with the 274 cam. I will be freshening my engine up this summer (new rings and bearings), and will be installing the head first with the stock manifold. After i get it running and everything is good with it i'll be installing the manifold and the throttle body. I'll let you know what type of gains you can expect. I should be able to get it to a chassis dyne at my local dragstrip and actually post some numbers. Sorry not willing to sell it, just wanted to let you know i'll be posting something midsummer about it.
Nice, that's pretty much the setup I'm going for. Let me know how it goes.
I picked up one of these from another member on here. Also purchased a bored throttle body from him too. I've recently purchased a myster-e head with the 274 cam. I will be freshening my engine up this summer (new rings and bearings), and will be installing the head first with the stock manifold. After i get it running and everything is good with it i'll be installing the manifold and the throttle body. I'll let you know what type of gains you can expect. I should be able to get it to a chassis dyne at my local dragstrip and actually post some numbers. Sorry not willing to sell it, just wanted to let you know i'll be posting something midsummer about it.
if it's from who i think it is... it's not "extrude honed", and the throttle plate is still 60mm. :(
Comment