WTB front floor pans

[bradnic]

If you're willing to chop out a passenger front floor pan and ship it to me in the Chicago area, please drop me a PM. Also looking for a rust free driver front floor pan, or at least the gas pedal area.

I need the foot well area from the tranny tunnel to the inner rocker, then up the firewall a couple of inches, then back to the raised area where the harness runs and the seat sits. Will update with pics once I find something, but here's what I'm trying to fix.

passenger footwell (outside front corner is completely gone, as is left side near trans tunnel)


driver footwell (not as urgent, except for the gas pedal area which is badly rusted. I've taken most of the tar stuff out since this pic)


I wish I could, but I just don't have the time or the portable tools to pull this myself - not to mention access to local shells in decent shape.

thanks much

[ThatOneEuroE30]

Go get a 4x8 sheet of 18-20 guage cold rolled steel and some andgle grinders with wire wheel, cutting wheel ,grinding wheel, and flappy disc. you said you have the welder thats the most expensive thing. just make sure you got some argon 75/25 mix and some .025 or .023 wire. Dont worry about the little dips in the floor pans just cut a sheet to fit the pan and weld that bitch in! Also If you can salvage pieces when you cut thems out use them as your template so you just trace,cut,weld makes life easy. got any more question let me know

[jaysonpwp]

pm'd

[bradnic]

Replied


Sent from my iPhone using Tapatalk

[bradnic]

Go get a 4x8 sheet of 18-20 guage cold rolled steel and some andgle grinders with wire wheel, cutting wheel ,grinding wheel, and flappy disc. you said you have the welder thats the most expensive thing. just make sure you got some argon 75/25 mix and some .025 or .023 wire. Dont worry about the little dips in the floor pans just cut a sheet to fit the pan and weld that bitch in! Also If you can salvage pieces when you cut thems out use them as your template so you just trace,cut,weld makes life easy. got any more question let me know

Great advice and I really appreciate it. Will probably do a combination of things here. I have lots of welding ahead of me :-)


Sent from my iPhone using Tapatalk

[bradnic]

Bump. This is what I'm looking for - for each section cut outside the inner rocker then a couple of inches above the floor.

[Matt-B]

I have a vert sheel, id think the pans are the same.

so I have both