WTB or WTT: performance catback

[bmwpower]

I have a fairly new Bosal I'd like to replace with something that makes a little more noise. :) Brullen, SuperSprint, etc. It's a track car, so if it's loud that's no problem. :)

If you want to trade + cash, even better.

Let me know what you got...

[Mars_e30]

One of my buddies has a Billy Boat Tri-Flow hes selling. $500.
It came off his 90 325is.
PM me if you're interested and I'll get you guys in touch.
Thanks! -Chris

[DrMcDave]

bb triflo is awesome I have one. I need something more quiet but i'm not committed to that yet.

[RickSloan]

i have a 2.5 inch straight pipe, with a thrush glaspac, and an OBX muffler. Its loud and sounds nice. I have from the header back cheap and local!

[bmwpower]

Guys, let me know if you want to trade or if you want me to buy outright. Thanks...

[RickSloan]

buy out right very cheap!

[bmwpower]

buy out right very cheap!

Shoot me a pict if you can. Curious to see...
PM if you have a price in mind.

[bmwpower]

bump.
Bought a set of long tube headers so I only need a catback.
Have stock fairly new condition Bosal to trade, if needed.

[JGood]

bump.
Bought a set of long tube headers so I only need a catback.
Have stock fairly new condition Bosal to trade, if needed.

Any reason you don't want to do a custom setup as opposed to the expensive name brand bolt-on kits? I did long tube headers to a y-pipe, single 2.5" stainless pipe with a Magnaflow cat and Borla straight-through muffler on both my m20 car and my m50 car. Sounds amazing IMO, not very loud at idle and low throttle loads, but up top it screams. I doubt you'll find something that flows much better, either. You can just put in flanges wherever you want for easy removal/installation.

I think both my setups were around $200 for the headers, $60 for stainless 2.5" pipe, $60 for the cat, $120 for the muffler, and then whatever tips you want. A local shop installed and welded everything with flanges where I wanted for around $150 labor.

[bmwpower]

Any reason you don't want to do a custom setup as opposed to the expensive name brand bolt-on kits? I did long tube headers to a y-pipe, single 2.5" stainless pipe with a Magnaflow cat and Borla straight-through muffler on both my m20 car and my m50 car. Sounds amazing IMO, not very loud at idle and low throttle loads, but up top it screams. I doubt you'll find something that flows much better, either. You can just put in flanges wherever you want for easy removal/installation.

I think both my setups were around $200 for the headers, $60 for stainless 2.5" pipe, $60 for the cat, $120 for the muffler, and then whatever tips you want. A local shop installed and welded everything with flanges where I wanted for around $150 labor.

I'm not against going that route. I've heard a lot of these types of systems and they seems kinda buzzy up high, but I guess they all do. I was also trying to spend little $. Spending $150 on labor would suck for me.

Although, I already have long tube headers (no cat) so I could nix the $60 for the cat.