German Engineering Suspension GB

[PNWDan]

Measurements of?

Sorry. what is the measurement from center of the front wheel to fender for reference?

[IRON-E]

As of now is pretty high, but I'm out and about with family today. Will get you #s tomorrow.

[noE30]

Installed the rear coils with my new IX bilsteins, everything installed fine. I set the adjuster completely down and i left both the adjuster and lock ring installed. You can definitely go low in the rear, granted my car is a late model.

[einstein57]

1 original group buy slot opened up. Next person to use the original code r3v280 gets their kit for $280.

[PNWDan]

1 original group buy slot opened up. Next person to use the original code r3v280 gets their kit for $280.

Damn lol.

[GrifM3]

1 original group buy slot opened up. Next person to use the original code r3v280 gets their kit for $280.

I'll take them, PM sent.

GrifM3

[einstein57]

Spot filled by grif

[mbonanni]

Dangit.

[graphikg]

If you want the 6" front springs I can send them out Monday.

Ill just take whatever the group buy deal was.

[einstein57]

The group buy deal was to meet expectations. If you expected a nice drop , have race camber plates,or just wanted a nice kit to use for sectioning your tubes then the 6" springs are for you. If you were expecting to be stanced right out the box with 0 modifications then the 4" spring is for you.

[801coppertop]

So if I don't want to be stanced, I shouldgoo with 6"? I don't want to have to cut the struts but I wanna be hr oe or a little lower...?

[einstein57]

Correct. If you decide to add camber plates at a later date it should put you in tire tuck country.

[ohthejosh]

Nigel, quick question. If I order a set with a 4" spring that will allow me to have that stanced look on its' lowest setting? I will have room to raise the car if need be yes?

[einstein57]

You will be able to bottom out the shocks on the lowest setting and have a a little over an inch of gap on the highest setting.

[801coppertop]

Are the rates for the 6" the same. If so I think I may do those because I do plan on getting your camber plates when there out. And I'm fine with the minor drop for the time being.

Edit: did some back reading, there same rate. I would like 6 in springs. Thanks for all your help!