5 Lug and BBK Group Buy Round 2 **NOW SHIPPING KITS

[elcoy]

Bump

[Jon_A]

HELP!

I just found out today I have the 72mm wheel bearing, not the 75mm one.
What the hell do I do?

I need wheel bearings with 42mm ID and 72mm OD.
Anyone know of any cars with theese bearings?

[mr2peak]

HELP!

I just found out today I have the 72mm wheel bearing, not the 75mm one.
What the hell do I do?

I need wheel bearings with 42mm ID and 72mm OD.
Anyone know of any cars with theese bearings?

You've contradicted yourself.

Use the normal E30 rear bearings.

[Jon_A]

You've contradicted yourself.

Use the normal E30 rear bearings.

No, there are two different wheel bearing sizes.

39x72x37 and 42x75x37

The Z4 flange (42mm) wont fit in my 39mm ID bearings.

[Toodaloo]

Any kits still available on the shelf? I'm interested in a full setup!

[elcoy]

Any kits still available on the shelf? I'm interested in a full setup!

I only have a couple left ready to ship today! Shoot me a PM if you are interested.

[Toodaloo]

I only have a couple left ready to ship today! Shoot me a PM if you are interested.

PM sent!

[LEANE30]

I'm interested in a kit. Pm incoming


Sent from my iPhone using Tapatalk

[LEANE30]

Elcoy, pm sent. Any available?


Sent from my iPhone using Tapatalk

[Toodaloo]

After seeing this kit in person, I can san say it's very nice quality. The machining and anodizing is very nice and the components are nice and lightweight! Unfortunately I have went a different route due to time/money limitations and have a ton of spare parts. If anyone is in need of calipers for their setup, shoot me a PM, I have a set of e46m3 calipers/carriers/lines/hardware, and 530i calipers/carriers/pads/hardware. I don't mean to thread jack, however I feel you guys are the ones looking for them, might as well post it here. Only shoot me private messages; I don't want to clog this thread with anything not related to the product at hand.

[acolella76]

HELP!

I just found out today I have the 72mm wheel bearing, not the 75mm one.
What the hell do I do?

I need wheel bearings with 42mm ID and 72mm OD.
Anyone know of any cars with theese bearings?

you need to swap to late model trailing arms. I went through the same issue

[LEANE30]

I'm interested in a kit. Pm me if you have one available.


Sent from my iPhone using Tapatalk

[elcoy]

I'm interested in a kit. Pm me if you have one available.


Sent from my iPhone using Tapatalk

Don't see a PM, but I sent you one!

[LEANE30]

Don't see a PM, but I sent you one!

Replied. What's the best source everyone know for rear drive flanges? Aside from Ecs


Sent from my iPhone using Tapatalk

[Jon_A]

you need to swap to late model trailing arms. I went through the same issue

Swapping trailing arms would have been my last resort since I've welded in reinforcements and had them blasted/powder coated.

I ordered some mazda 626 bearings, they are 42x72x38.
I took half a mm off the outer ring each side and went for it =)
The half mm either side on the inner ring will not affect anything.