If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I went to buy some today from a guy and as he was trying to take them off this happened...it physically broke his alan key socket off! I never did buy them and he will be drilling the bolts out.
after having these on for a bit over a month, i have one question/concern.
i'm not sure if i'm the only person that had an issue with this, but the nuts tightened themselves to well over 100 lbs/ft after first fitment (i torqued them with a wrench to 75-80 lbs/ft) i don't typically have access to an impact gun, so i attempted to remove them with a 6-point/breaker and ended up nearly rounding off about half the nuts (mixture of very shallow nuts and deep center wheels). i went ahead and purchased some 75mm nuts from motorsport tech (problem solved), but i was a little concerned with how soft the nuts were considering their shallow nature.
Comment