If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
::ESM-002R Now Available in 15x8 16x8 16x9 SAME OLD HUGE STEP LIP:)
Just mounted a set of 15x8 white on my daily. IM VERY HAPPY WITH THE LOOK:) I have also added 20mm spacer for the fenders but they are a direct bolt-on for the E30.
I'm running a lowered e30 on j-stock springs, revalved bilsteins and the original ESM 16x9 et10 002's all around. I love the 002 wheels but I'm just not into the stretched tire look. I bought the car with 205/40/16's on the front and 215/40/16's on the back.
Is it possible to run the new 16x8's all around with 225/45/16's or perhaps 215/45/16's? I think this would be ideal for me, assuming I wouldn't need to run any spacers. FWIW I do have a slight fender roll. Ideally I want to run a flush setup with as much rubber on the ground as possible and not have the rim sticking out beyond the tire.
Could I get away with 225/40/16's in the rear on the 16x9's et10's that I already own? I ask because the 215/40/16's currently on the rear wheels aren't quite wide enough to protect the rim.
Any input greatly appreciated....apologies for the rambling post
ZF320 | M50 Mani | TRM + 21.5lb Injectors + 3.5in MAF | E36 M3 Rack/Driveshaft | Megan Coilovers | 002R/452's In the works: UUC Evo 3/DSSR, JB Racing lightweight Flywheel, Shrick cams, BBK (yet to be determined) I NEED A WINGLESS AW TRUNK LID PLEASE PM ME IF YOU HAVE ONE!
I'm running a lowered e30 on j-stock springs, revalved bilsteins and the original ESM 16x9 et10 002's all around. I love the 002 wheels but I'm just not into the stretched tire look. I bought the car with 205/40/16's on the front and 215/40/16's on the back.
Is it possible to run the new 16x8's all around with 225/45/16's or perhaps 215/45/16's? I think this would be ideal for me, assuming I wouldn't need to run any spacers. FWIW I do have a slight fender roll. Ideally I want to run a flush setup with as much rubber on the ground as possible and not have the rim sticking out beyond the tire.
Could I get away with 225/40/16's in the rear on the 16x9's et10's that I already own? I ask because the 215/40/16's currently on the rear wheels aren't quite wide enough to protect the rim.
Any input greatly appreciated....apologies for the rambling post
I stand up, pull my dick out, and asked my gf to give me some noggin... Well, she starts laughing at me and I freaked out and ran off and locked myself in a bedroom.
Comment