I have been putting together my first e30 s54 swap and have had trouble trying to get it to run. It starts for a second and then dies. My setup includes:
Walbro Fuel Pump (High pressure, 5.5 bar)
Stock s54 FPR
Modified my DME with ECUWORX tool(EWS removal). Is there anything else I need to do to it??
The Error Codes I get are:
139 Interruption, cruise-control operation
44 2C YES Signal, thermal oil level sensor
81 51 P1568 Interface, multifunction steering wheel
132 84 P1613 CAN timeout DSC
133 85 P0600 CAN timeout, steering angle sensor
134 86 P1612 CAN timeout, instrument cluster
79 4F P1490 Signal, temperature sensor, exhaust gas
106 6A Signal, brake light switch
66 42 EWS interface: no communication
43 2B Signal, temperature sensor, radiator outlet
All these error codes make sense, since I have eliminate all this stuff. Any help would be greatly appreciated. I've checked most of the sensors in INPA and they all seem to be reading. I've tried to delete adaptations. I've tried with the maf plugged in and not plugged in.
Any help would be greatly appreciated.
Walbro Fuel Pump (High pressure, 5.5 bar)
Stock s54 FPR
Modified my DME with ECUWORX tool(EWS removal). Is there anything else I need to do to it??
The Error Codes I get are:
139 Interruption, cruise-control operation
44 2C YES Signal, thermal oil level sensor
81 51 P1568 Interface, multifunction steering wheel
132 84 P1613 CAN timeout DSC
133 85 P0600 CAN timeout, steering angle sensor
134 86 P1612 CAN timeout, instrument cluster
79 4F P1490 Signal, temperature sensor, exhaust gas
106 6A Signal, brake light switch
66 42 EWS interface: no communication
43 2B Signal, temperature sensor, radiator outlet
All these error codes make sense, since I have eliminate all this stuff. Any help would be greatly appreciated. I've checked most of the sensors in INPA and they all seem to be reading. I've tried to delete adaptations. I've tried with the maf plugged in and not plugged in.
Any help would be greatly appreciated.
Comment