I have tested the wiring a few ways started with a coil and plug and changed out each set of coil wires and got spark arc when cranking on all but wires for cylinder 1.
From there I tested the wires...
power on I get 12v and ground with the multimieter and ground is good
I checked the signal wire from harness to pin 50 and have continuity.
what can I test next? I cant find anything that says what the signal wire should be tested at using multimeter.
Also with wiring testing good is it possible the dme is bad and not sending a proper signal?
Need to get this sorted so I can swap motors and nkt be chasing an already existing demon
From there I tested the wires...
power on I get 12v and ground with the multimieter and ground is good
I checked the signal wire from harness to pin 50 and have continuity.
what can I test next? I cant find anything that says what the signal wire should be tested at using multimeter.
Also with wiring testing good is it possible the dme is bad and not sending a proper signal?
Need to get this sorted so I can swap motors and nkt be chasing an already existing demon
Comment