Which of these knock sensors go where?
What did this go to?
Here's the M52 in the works!
What did this go to?
Here's the M52 in the works!
-
-
The knock sensors get bolted to the drivers side of the engine block.Your signature picture has been removed since it contained the Photobucket "upgrade your account" image. -
Yeah haha I ment. How would I figure out which goes to 1-3 and 4-6?Comment
-
Put the harness on the engine, see which sensor can most comfortable reach the mounting holes. The harness should be longer for the 1-3 sensor and shorter for the 4-6 sensor.
If not, bust out the etm, find one pin on the dme's connector (ex: bank 1-3 ground wire) and trace it back to the knock sensor with a meterComment
Comment