anyone using a borla 40349 muffler

[M-technik-3]

I am getting ready to redo my system to a 3" pipe and was considering going to something similar to this.

http://forums.bimmerforums.com/forum/showthread.php?t=1506995

[5ickride]

More info on this setup please?

[nando]

that looks pretty good, but I wonder if you'll have enough room on the E30 to reduce the tip spacing down like that without having an extreme angle.

I prefer a single in/out for simplicity but finding a good looking single tip for a 3" muffler is impossible.

[M-technik-3]

Yeah I came across the thread on BFc, I have consider making the exit hole bigger is needed. Basically it will take some mocking up.

[e30polak]

We built that exhaust at the shop. It's my buddy Nathan's car. Sounds amazing, but yes the dual exit is simply retarded. I'd say get a single center in, center out, and make a y-pipe for the tips if you want 2.

My 2 cents.

[5ickride]

More info on your buddy's setup please. I have dual straight from headers to muffler. I've bought an E36 M3 midpipe but not sure which route to go. I like how this looks; clean and simple. Thanks

We built that exhaust at the shop. It's my buddy Nathan's car. Sounds amazing, but yes the dual exit is simply retarded. I'd say get a single center in, center out, and make a y-pipe for the tips if you want 2.

My 2 cents.

[M-technik-3]

We built that exhaust at the shop. It's my buddy Nathan's car. Sounds amazing, but yes the dual exit is simply retarded. I'd say get a single center in, center out, and make a y-pipe for the tips if you want 2.

My 2 cents.

Wanting a twin out for looks as having a single out a Tech I will look silly, who knows, I might change my thoughts on exhaust again soon anyway. The tip build looks to be the hardest part.

[5ickride]

More info on this setup please?

Nevermind, just noticed the link below the pic DOH!!

[e30polak]

Wanting a twin out for looks as having a single out a Tech I will look silly, who knows, I might change my thoughts on exhaust again soon anyway. The tip build looks to be the hardest part.

Ya, so do as I said: get a single out & just make a y-pipe, then weld 2 tips to it. The dual out will make things near impossible if you use the same size muffler.