went to test my crank position sensor and i get no resistance between pin 1 and 2, ive tried on three different cps and get nothing, is this normal if its dead, i would expect some resistance on at least one of the sensors, one of them is only 2 months old. Am i testing it wrong?
-
1988 325is alpine
1989 325is zinno RIP
1992 325ic alpine
1986 325e cirrusblau -
These are OBDI VR CPS's with only two pins right? Are the leads on your multimeter plugged into the right spots? Is the meter set to the right range?
I would say that yes without a doubt you are testing them wrong if these are two pin cps's
'89 Alpine S52 with goodies -
i think its a hall sensor, 3 pins and its magnetic at the tip...
I double checked my multi meter, used all the ranges, busted out my old cheepy multi meter tried that one through its ranges, i get proper resistance on other components
I must be testing it wrong though no way i have three shit cps with no reading... unless thats what they read when these things crap outLast edited by 325islovE; 03-03-2011, 09:19 PM.1988 325is alpine
1989 325is zinno RIP
1992 325ic alpine
1986 325e cirrusblauComment
-
fixed
replaced multi meter bat. and retested, the new one i spent 80 bucks on is dead w/no reading old reads 505 ohms1988 325is alpine
1989 325is zinno RIP
1992 325ic alpine
1986 325e cirrusblauComment
Comment