I guess I should finally post something, doing a m50 swap soon
Collapse
X
-
damnnnn i got lucky today. the only e36 in the junk yard and it has a non vanos motor with harness and ecm just waiting for me to pull it. here all that i got for 75 bucks
engine harness, matching ecm, the correct oil cap, e36 engine bracket arms, little elbow off the throttle body, and thermostat housing that i needed.

Uploaded with ImageShack.usLeave a comment:
-
well since i am an idiot and hacked the harness that i was supposed to keep i have no idea what goes where. im gonna pick up a harness off of someone here soon but im pretty sure it wont be to hard to figure out which clip goes where. we will see though. thanks for the advice guys. going to get a new valve cover gasket and my e36 arms today. maybe order my e28 mounts too.Leave a comment:
-
-
here is the head, looks pretty clean

Uploaded with ImageShack.us
is it normal to have the tensioner pop up and down as you turn the crank? the one between the intake and exhaust cam

Uploaded with ImageShack.usLeave a comment:
-
I think that auto mod is done in the cab and to the chassis harness. I have done it once before on my old 90 325i.
I pulled my valve cover off today to find a pretty damn clean head. I'm hoping the rest of the engine is as healthy head looks. It seems as if the previous owner never replaced the valve cover gasket. It was rock hard and the spark plug holes were halfway filled with oil. Valve cover gasket will be bought tomorrow
also the tranny will be mounted. I already modified the e34 oil pan to fit the stock m20 single mass flywheelLeave a comment:
-
If you're using an ecu out of an auto car there's some mod you have to do to override neutral saftey I think but don't know what off hand. The wiring harness can be looked up depending on year car and engine. There's slight color differences but it's not bad.Leave a comment:
-
-
....and take notes and photos,for your next swap.....there will be one;)Leave a comment:
-
The car I am pulling the motor out of has a silver label idk the numbers yet or if its a vanos motor. Ill have to check when I go back. I couldn't make it todayLeave a comment:
-
-
haha played out is good for me, that means most people have already ran into all the issues. Im gonna have lots of fun with it for sure. I will have to post up everything else I have done to the car so far soon. I wanna get the engine in the bay before posting it up though.
Ill try not to be to annoying with the questions but the wiring still worries me. The rest I think I have under control thanks to this site and googleLast edited by 2poor2tune; 03-14-2011, 04:47 PM.Leave a comment:
-
M50 swaps are so played out.
;)
If the valve cover is just squared off at the front, it's a non-vanos. If it has a kind of round "bulge" at the front, it's Vanos, and that's the Vanos unit.
Awesome to see another swap, I've had so much fun with mine so far. There's tons of great info all over this place, some of it can be a little hard to find at times. Don't be afraid to ask questions, but please, search for what you can before you just start posting threads for every question. I'm more than happy to answer anything I can, and so are most of the others that have done 24V swaps.Leave a comment:
-

Leave a comment: