Need help m50 NV 92, crank no start

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • 416stroker
    replied
    It sounded right to me but I didn't thin that's something someone would overlook

    Leave a comment:


  • bmwm42
    replied
    didnt i say your timing was off at abes bbq but you guys doubted me

    Leave a comment:


  • Matt-B
    replied
    AH motherfucking HA

    i took trigger wheel off, i had no guide pin, so i went to woodland washington where a guy is parting an e36, stole the pin and gave him 5$, i was about 180degrees off from my timing...

    IT WILL RUN TOMORROW I SWEAR

    Leave a comment:


  • xwill112x
    replied
    i wouldnt say timing is bad.. you have a gremlin somewhere.. split open the harness loom and do a wiggle test..wiggle and tug all your wires while cranking to make sure theyre not in just a bad spot shorting out or giving you an open. fairly easy to do and narrows things down to the wiring rather than mechanical.

    Leave a comment:


  • Jand3rson
    replied
    There would still be a hole on the mounting face where the crank trigger wheel goes, and a hole for it on the wheel itself. Just line them up, and bolt it down.

    My dowel was down in the hole a bit, I just stuck a flathead screwdriver behind it, whacked it once with a hammer, and it popped back up.

    Leave a comment:


  • 416stroker
    replied
    Possable

    Leave a comment:


  • LJ851
    replied
    ^ unless the pin fell out.

    Leave a comment:


  • 416stroker
    replied
    Originally posted by Matt-B
    Hmm I did not see a locating pin. Just throwing ideas.
    It should My n/v did.


    If you didnt set it on the pin you should have seen if it was cocked before you torqued it down? I guess pull it off and check. If you did miss the hole you going to need a new one because its going to be bent.
    Last edited by 416stroker; 04-25-2011, 05:27 PM.

    Leave a comment:


  • Matt-B
    replied
    this thread makes me wonder

    Bimmerforums is the preferred online BMW Forum and community for BMW owners. At Bimmerforums, you will find technical how-to information maintenance specifics audio advice wheel and tire combinations and model specific details not found anywhere else. Our professionals are here to help make sure you find the answers you need to your questions and our community is here to help other brainstorm ideas for the future.

    Leave a comment:


  • LJ851
    replied
    Originally posted by LJ851
    If you have fuel and a good spark, all you are missing is timing.

    Leave a comment:


  • Matt-B
    replied
    Hmm I did not see a locating pin. Just throwing ideas.

    Leave a comment:


  • 416stroker
    replied
    yup

    Leave a comment:


  • White325is
    replied
    The trigger wheel will only go on one way because it has a locating pin.

    Leave a comment:


  • Matt-B
    replied
    If i took off the trigger wheel, and did not put it back on in the exact same spot? That throw timing off, and make it rich, lean etc

    Leave a comment:


  • 416stroker
    replied
    If it wont fire then you know you have a weak spark is shouldnt take much fuel just to hear fire for a second or two
    Last edited by 416stroker; 04-25-2011, 02:20 PM.

    Leave a comment:

Working...