Need help m50 NV 92, crank no start

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Matt-B
    replied
    ok ill try that

    Leave a comment:


  • 416stroker
    replied
    no real fuel . put like a half a paint cap in the throttle body. If it evan wants to run is shold run for 3-4 seconds. dont use starting fluid thats stuff all bad.
    Last edited by 416stroker; 04-25-2011, 02:07 PM.

    Leave a comment:


  • Matt-B
    replied
    like starter fluid, and pulling fuel pump relay and fuse? yes I have

    Leave a comment:


  • 416stroker
    replied
    Originally posted by 416stroker
    Have you tried disabling the fuel pump and priming the manifold with fuel to see if you can even get it to fire without the pump running?

    Leave a comment:


  • Matt-B
    replied
    If my DME is not getting power from my C101, will i still get fuel and spark?

    Leave a comment:


  • Farbin Kaiber
    replied
    I also stand behind the hardwire option, but in a different manner, tie into the e30 m20 harness behind the connector. Then you still have an engine removal harness quick disconnect.

    Leave a comment:


  • Matt-B
    replied
    My adaptor had like the coolant temp wired into DME power, not sure what that would have made car to, jumping car soon AGAIN, and trying to locate legit pin out charts

    Leave a comment:


  • Jand3rson
    replied
    Originally posted by ck_taft325is
    Hard wire it if you can.
    This. I'm so glad I didn't stick with that hodge-podge adapter, hardwiring it in is so much better.

    Leave a comment:


  • ck_taft325is
    replied
    Originally posted by Matt-B
    I did not no, possible problem with adaptor, looking into now, on the phone emailing, and on skype as we speak
    Hard wire it if you can.

    Leave a comment:


  • e30rapidic
    replied
    this is what I have, mine fired up first time.....luckily
    e34 harness to '87 325i

    oil pressure sensor BRN/GRN or BRN/GRY
    front coolant temperature sensor (ECU) BRN/RED BRN
    rear coolant temperature sensor (Gauge Sensor) BRN/YEL BRN/VIO
    crank position sensor YEL
    cam position sensor YEL RED/WHT BRN/ORG
    VANOS solenoid RED/WHT GRN/BLU
    knock sensor, 1-3 BLK NCA DME PIN 70
    knock sensor, 4-6 BLK NCA DME PIN 69
    throttle position sensor (TPS) BRN BRN/BLK RED/YEL
    intake air temperature (IAT) sensor BRN GRY
    idle control valve (ICV) WHT/YEL RED/WHT WHT/GRN


    pin color description m50 pin
    1 blue alternator 25
    2 green/yello oil level (static) 1
    3
    4 brown coolant temp 12
    5 brown/green oil pressure switch 23
    6 green/white fused power O2 22
    7 green ignition coil use large 21
    8
    9
    10 blue oil level (dynamic) 2
    11 white/green service lights reset 19
    12 grey CEL 8
    13 green/violet fuel pump 13
    14
    15
    16 white/black SRS (unused) 17
    17
    18 black/yellow starter 18
    19
    20

    Leave a comment:


  • glucklich21
    replied
    I remember why I hated the E34 ETM tonight. x-x

    Leave a comment:


  • Matt-B
    replied
    I did not no, possible problem with adaptor, looking into now, on the phone emailing, and on skype as we speak

    Leave a comment:


  • Adrian_Visser
    replied
    You didn't by some chance replace the harmonic balancer did you? NV and Vanos trigger wheels are different and will cause a no start. Just fishing.

    Leave a comment:


  • 416stroker
    replied
    Its dumping in to much fuel still?
    After your plugs fuel fouled did you change them?

    A fouled plug will give you a weak spark and a misfire. Drying them out doesn't work there don't always bounce back.

    Have you tried disabling the fuel pump and priming the manifold with fuel to see if you can even get it to fire without the pump running?

    Id rule out the cps because IIRC it will disable fuel and spark if its not working
    Last edited by 416stroker; 04-24-2011, 10:52 PM.

    Leave a comment:


  • Jand3rson
    replied
    I understand that, but you need to give people more than an hour to check things out. It's 11:30 on this coast, but later everywhere else.

    Leave a comment:

Working...