What clutch to use with Euro 323i Flywheel???

[bubbajan21]

Trying to help put the correct info out there:

9/83-4/86 etas: SINGLE MASS Bellhousing depth- 6 1/2
5/86-6/88 etas: DUAL/TWIN MASS Bellhousing depth- 6 7/8
325i: SINGLE MASS Bellhousing depth- 6 1/2
318is m42: dual
And i believe the m10 318's have single.

If you have a trans from a twin mass car going on a single mass, use the 323i throw out.

Thank you, this is very informative. I bought the 86-92 Clutch Kit this afternoon and it is in fact a sprug hub which supports your info. I have ordered all of the parts as well as the 323i Throw out bearing (P/N 21511204525).

[bubbajan21]

Bringing this thread back for a question. Everything is bolted up and put together and I am trying to start my car. The starter in my car won't start the car. I am using the M20 starter which, according to everything I have read, should start up the car with no problems. With the starter out of the car, it does spin and the solenoid does push out the gear. I don't know why it won't start, but I have an E21 323i starter on the way. Could it be an early/late model thing? I did see that there were 2 different starters for an M20 and the application for the e21 is different than the early starter. My car is an 87 and the cutoff for the early starter is (12/86). Any info would be appreciated.