M50 sensors

[A_Whelan]

Hello,

My swap is almost at the end but I need to figure out what sensors go where. I can get the colors of the wires but is there any way to look this up in the ETM? The only way I would know how is page by page looking at every wire, but there has to be an easier way. I find the ETM a bit confusing and I'm not really sure how to navigate through it to find the information I want.

Help greatly appreciated,
Aaron

[samiam3356]

Find the pin out of the dme and run a continuity test on the connectors. Way faster imo

[A_Whelan]

I assume the DME pinout is in the ETM somewhere?

[N2MYE30]

I followed the colors of the wires and matched them to the ETM.

[giantkeeper]

From the swap wiki, and also what I used on mine.

oil pressure sensor BRN/GRN or BRN/GRY

front coolant temperature sensor (ECU) BRN/RED BRN

rear coolant temperature sensor (Gauge Sensor) BRN/YEL BRN/VIO

crank position sensor YEL

cam position sensor YEL RED/WHT BRN/ORG

VANOS solenoid RED/WHT GRN/BLU

knock sensor, 1-3 BLK NCA DME PIN 70 (actually numbered on the wiring sleeve)

knock sensor, 4-6 BLK NCA DME PIN 69 (actually numbered on the wiring sleeve)

throttle position sensor (TPS) BRN BRN/BLK RED/YEL

intake air temperature (IAT) sensor BRN GRY

idle control valve (ICV) WHT/YEL RED/WHT WHT/GRN

Evaporative emissions valve BRN RED/WHT

[A_Whelan]

Awesome! I missed that on the swap wiki, thanks giantkeper

[giantkeeper]

Awesome! I missed that on the swap wiki, thanks giantkeper

yessir, you bet :up: