M50NV cuts out going from idle to WOT

[trackjunkie21]

Cam sensor retards/advances ignition timing

[blueapplesoda]

cam sensor sends a signal to the ECU to decipher which cylinder is on what cycle, for sequential fuel and spark.

[lolcantturn]

Hmmmmmmmm...that seems kind of correlated. you see, sometimes I feel like I hear an intake backfire? I feel it in the throttle pedal, which can be from the cam sensor fucking up..

[lolcantturn]

shall I point out that, when the car dies, it has NO problem starting back up, as if nothing ever happened.

I have no vacuum leaks (smoke tested) ...

[trackjunkie21]

shall I point out that, when the car dies, it has NO problem starting back up, as if nothing ever happened.

I have no vacuum leaks (smoke tested) ...

Idle Control.

[lolcantturn]

DEARi KAMIL,
I DONT THINK MY ICV IS GONNA CAUSE CUT OUTS

SINCERELY,
LAUGH OUT LOUD, CANNOT TURN.

[trackjunkie21]

DEARi KAMIL,
I DONT THINK MY ICV IS GONNA CAUSE CUT OUTS

SINCERELY,
LAUGH OUT LOUD, CANNOT TURN.

Yeah but you said you start the car and it dies at idle, hence why I said Idle Control.

[lolcantturn]

Yeah but you said you start the car and it dies at idle, hence why I said Idle Control.

noooo, when the car dies when im cruising on the highway or when I'm doing a WOT pull, it starts back up immediately. my idle is pretty neat right now.

[TimKninja]

It has nothing to do with your vent thingy. I have mine set up similar except its still plugged in.

Did you change your TPS? Get a JY one for the lulz.

[trackjunkie21]

After checking the car out today, the problem seems fuel related, After messing with the injector harness ground wire the car ran somewhat better and didn't cut out as often, I'm suspecting an old clogged filter is causing most of the issues.

[lolcantturn]

It has nothing to do with your vent thingy. I have mine set up similar except its still plugged in.

Did you change your TPS? Get a JY one for the lulz.

didn't change the TPS, I don't think I have to, I didn't ohm it out yet but stomp test works great

After checking the car out today, the problem seems fuel related, After messing with the injector harness ground wire the car ran somewhat better and didn't cut out as often, I'm suspecting an old clogged filter is causing most of the issues.

Replaced fuel pump now im putting a new filter in......

The car had 9month old gas in it before i started the M50, i guess it's all clogged up. I hope at least. tired of throwing parts at this.

[trackjunkie21]

It has nothing to do with your vent thingy. I have mine set up similar except its still plugged in.

Did you change your TPS? Get a JY one for the lulz.

TPS was checked and verified working

[lolcantturn]

Also not running coil grounding straps tho I doubt that has anything to do with this

[TimKninja]

Nor am I. Those arent relivant.

[e46s54dr]

Also not running coil grounding straps tho I doubt that has anything to do with this

BMW put those little ground straps are there for a reason. Each coil is grounded to the valve cover individually and those straps are just there as a backup measure. Sure it doesnt hurt not to have them, but why not have them as free insurance?

"The studs go into the valve cover which is separated from the head with a rubber gasket. How well is that going to ground to the block? The only connection between the head and the coil is through the small contact point at the top of the spark plug. The early M50's with the almn. valve covers provided some grounding but the later M52's with the plastic valve covers have zero grounding properties. I'm not just pulling stuff out of the air here, I work at a BMW shop and have seen this problem. 90% of the time when a coil starts to short out or isn't grounded properly and it isn't taken care of in a timely matter the DME will die"