s50 crank with m52 pistons?

[thedean]

I have at my disposal a m52 shortblock with all the internals as well as an s50 crank.

Anyone know what my static CR will be if I use the s50 crank? The piston should move up 1mm total due to the difference in stroke increasing from 84mm to 86mm. Will this cause interference?

What I would really like, if anyone has them, or knows where I can find them, are the wrist pin heights for all the different m5x pistons.

Thanks,

Michon

[blink977]

Use compression ratio calculator. Here's one: www.dragsource.com

[thedean]

Use compression ratio calculator. Here's one: www.dragsource.com

Yes but I don't know the volumes of the compression chamber or piston indents, stock HG thickness etc... I was hoping someone could chime in about that lol.