My m50 is pinging. Running out of ideas.

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Wishno87
    replied
    Just did the smoke test again. The only place I see smoke coming from is the oil filler cap. It couldn't be that could it?

    Leave a comment:


  • Ryann
    replied
    In for results on Seafoam.

    Leave a comment:


  • Tchao
    replied
    If your car is pinging...you will definitely see Aluminium deposits on your spark plug.

    If your other M50 is also having the same issue...id drain the gas and buy from different gas stations around your area to see if you got bad gas.

    Leave a comment:


  • meanEG
    replied
    Originally posted by Wishno87
    Man I wish it were that easy but the management on mine is all stock. I couldn't even imagine running a chip at this point. Going to try seafoam today as well as swap mafs and the ecu.
    I have had great results with BG products. Try to find someone in your area that carries them. It is an expensive service usually $100-200. I have used them professionally in the past. It will improve injector spray and carbon deposits on the intake valves. It may help with piston tops as well. Be sure to do the service when hot. You should put new plugs in as well when completed. Should change the oil afterwards as well. Are the plugs clean/tan/white/ black/carbonded up?

    Leave a comment:


  • Wishno87
    replied
    Man I wish it were that easy but the management on mine is all stock. I couldn't even imagine running a chip at this point. Going to try seafoam today as well as swap mafs and the ecu.

    Leave a comment:


  • justin_l_
    replied
    What are you guys running for tunes? Maybe there is just too much timing for the motor? I remember my old orange car with a mark d chip would ping, that was a non vanos motor. Swapped chips and it was gone.

    Leave a comment:


  • Ryann
    replied
    No CEL. Recently pulled the plugs and scoped the chambers, definitely some carbon in there. Scraped a piston top and it looked like a fairly thin layer.

    Leave a comment:


  • Wishno87
    replied
    So if yours isint running lean then maybe carbon deposits? Do you get any cels?

    Leave a comment:


  • Ryann
    replied
    As far as I know and can think of it is ignition timing rather than cam timing that would cause preignition, so the VANOS thing doesn't add up for me. Adding to the mystery is that I can drive down the road and watch my a/f on the Modis and it's damn near perfect the whole time.

    Leave a comment:


  • Wishno87
    replied
    Spent the last two hours researching this on forums and I did not find one single thread where someone successfully remedies this issue except for one. Some guy replaced his vanos unit and it stopped pinging. Maybe the timing was too advanced?

    Then again I see people with m60s and the same issue and they have no vanos.

    Leave a comment:


  • Wishno87
    replied
    Originally posted by Ryann
    In for a definitive solution here. Having this exact issue. Know of a couple others also. I will add that mine seems to disappear at about 2900 rpm or so.

    Edit: have you tried unplugging the intake air temp sensor?
    Downshifting does usually help when I'm on the highway. The intake air temp sensor is new but at this point I will try just about anything.

    Leave a comment:


  • Wishno87
    replied
    When I pulled my intake to change the knock sensors and intake gaskets the injectors looked brand new but I will run some injector cleaner though it.

    Could the fpr have anything to do with it? Not enough fuel pressure?

    Leave a comment:


  • mpowerful
    replied
    The other thing that can cause pinging besides iat that are high is running excessively lean. Fuel cools the charge making it less likely to detonate up to a point. Try cleaning your injectors.

    Leave a comment:


  • Ryann
    replied
    In for a definitive solution here. Having this exact issue. Know of a couple others also. I will add that mine seems to disappear at about 2900 rpm or so.

    Edit: have you tried unplugging the intake air temp sensor?
    Last edited by Ryann; 06-03-2014, 11:06 PM.

    Leave a comment:


  • Wishno87
    replied
    Originally posted by justin_l_
    Care to elaborate? Plan on installing a podi setup this weekend.
    On topic, carbon deposits can cause pinging. Have you tried to run higher octane fuel (unleaded race fuel of some sort) to see if it goes away?
    I installed it a few months ago and nothing on it works. The wiring should be pretty simple but somehow everything either doesn't read or reads some crazy number. It may end up being an easy fix but I don't have the will to dig out all the wiring to look at it again.

    Would the seafoam help with the carbon deposits? I could try some octane booster but that would just be a very temporary bandaid. It has never done this before so it would be a fixable issue.

    Leave a comment:

Working...