Guide to your OBD2 swap! Diagnostics and logging

[craiggroves91]

Would we be able to read live oil and water temps?

[NC325iC]

OK I figured it out. I imagine that I have c104 pin 2 connected to x20 pin 21 providing ecu power

I will need to review and see if I have connection to x20 pin 22. But I believe I do because I get +12 at all the right pins in the diagnostic plug.

Sent from my ONEPLUS A3000 using Tapatalk

[NC325iC]

Green/White22Green/Yellow6O2 Sensor Heater
Green21Green7Ignition

I know you are trying to help me, but I don't know what you mean when you just list colors and numbers

Sent from my ONEPLUS A3000 using Tapatalk

[328ijunkie]

What do you connect them to on the e36 side?

Sent from my ONEPLUS A3000 using Tapatalk

Green/White 22 Green/Yellow 6 O2 Sensor Heater
Green 21 Green 7 Ignition

[NC325iC]

What do you connect them to on the e36 side?

Sent from my ONEPLUS A3000 using Tapatalk

[NC325iC]

Like I said that was the only description I wrote down that I could find.

Sent from my ONEPLUS A3000 using Tapatalk

[craiggroves91]

I really need to do this...

[328ijunkie]

Missing nearly everything. How is the car running with no pin 7? Pin 6 powers the diag port.

[NC325iC]

To the best of my memory/documentation this is how its wired

[328ijunkie]

how did you wire C101?

[NC325iC]

Harness is from a 96/97 e36 m3 auto, I removed the automatic transmission wiring as well as the other unnecessary wiring for sap etc...

The adapter is one from Amazon. Goliton is the brand.

On my Bluetooth adapter, o get the red light for power always, but I never get the green light that should turn on with ignition.

Sent from my ONEPLUS A3000 using Tapatalk

[328ijunkie]

I can't seem to get the obd2 adapter to read anything. I am using the diag port adapter and a bt obd2 reader. I know the reader works, used it in my wife's car. I can connect to it when it's in my car, so it has power. What could be wrong that it doesn't get signal from the ecm?

Sent from my ONEPLUS A3000 using Tapatalk

Ive had some diag port adapters be DOA. I would also confirm the Kline is where it should be in the diag port. What harness/adapter are you running?

[NC325iC]

I can't seem to get the obd2 adapter to read anything. I am using the diag port adapter and a bt obd2 reader. I know the reader works, used it in my wife's car. I can connect to it when it's in my car, so it has power. What could be wrong that it doesn't get signal from the ecm?

Sent from my ONEPLUS A3000 using Tapatalk

Anyone?

Sent from my ONEPLUS A3000 using Tapatalk

[Mushi]

Sub'ed

[NC325iC]

I can't seem to get the obd2 adapter to read anything. I am using the diag port adapter and a bt obd2 reader. I know the reader works, used it in my wife's car. I can connect to it when it's in my car, so it has power. What could be wrong that it doesn't get signal from the ecm?

Sent from my ONEPLUS A3000 using Tapatalk