Starter winding but not spinning

[George E30]

Hey guys I finally figured everything out after chasing around problems left and right, I started testing all connectors on DME and my problem was it did not get signal from ignition. I then traced the green wire, pin 49 from DME to end of the harness which connects to pin 6 on the e30, my harness was connected to pin 7 with another ground wire, so somehow signal would not go through, anyways I cut the harness pin 49 (green wire) and jumped it from there to the c101 pin 6 boom worked like a charm,

Sent from my SAMSUNG-SM-G890A using Tapatalk

[CENTURION]

yeaaaa buddy!

[George E30]

Yeah an what a frustration, now I gotta rewrap the harness and go from there again

Sent from my SAMSUNG-SM-G890A using Tapatalk

[George E30]

Hey got another question I'm under the car getting the drivrshaft connected you have any tips on how I can get that installed, do I need yo cut/ grind anything ?

Sent from my SAMSUNG-SM-G890A using Tapatalk

[George E30]

Yes I drink Hennessey privilege while doing my work 😊😁😁

Sent from my SAMSUNG-SM-G890A using Tapatalk

[CENTURION]

lookin good.
that depends on what transmission and guibo that you have. I had to because of the output flange on my zf.

[George E30]

I'm using the getrag260 and the stock guibo

Sent from my SAMSUNG-SM-G890A using Tapatalk

[George E30]

She's done wooohoooo thanks for the help guys

Sent from my SAMSUNG-SM-G890A using Tapatalk

[CENTURION]

nice man. is your exhaust completed already?
if your using getrag trans, there shouldn't be any modification for guibo and driveshaft.

[George E30]

Yeah, I figured it out on how to get that in, no I don't have exhaust yet, any suggestions?

Sent from my SAMSUNG-SM-G890A using Tapatalk

[CENTURION]

your in LA right? I wouldn't know man, you gotta ask around.
I'm a long ways from there.
I'm trying to do my own exhaust. 2 to 1, 2.5" all the way back.
I've got oem e36 m3 obd2 midsection if you wanna use that. pm me if interested. I was gonna go with dual but changed my mind.

[328ijunkie]

Hey guys I finally figured everything out after chasing around problems left and right, I started testing all connectors on DME and my problem was it did not get signal from ignition. I then traced the green wire, pin 49 from DME to end of the harness which connects to pin 6 on the e30, my harness was connected to pin 7 with another ground wire, so somehow signal would not go through, anyways I cut the harness pin 49 (green wire) and jumped it from there to the c101 pin 6 boom worked like a charm,

Sent from my SAMSUNG-SM-G890A using Tapatalk

Who did your harness?

[George E30]

Kassel performance

Sent from my SAMSUNG-SM-G890A using Tapatalk

[328ijunkie]

Makes sense :|

[George E30]

I wish I knew

Sent from my SAMSUNG-SM-G890A using Tapatalk