Announcement

Collapse
No announcement yet.

E30 clutch with S50 flywheel?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    E30 clutch with S50 flywheel?

    will it work? My guess is the pressure plate is different.

    I searched btw, didn't come up with much.

    #2
    i doubt it will. an m20 flywheel must be used with it same with a pressure plate.
    its a good in a way since u can get the single mass lightened.

    www.stancefactory.com

    Comment


      #3
      I know the clutch disk is interchangeable between e36s and e30s with the 228mm clutch. I went through this with a guy at clutch net. I am assuming the flywheel/PP is different because I hear people using the m20 flywheel on the m/s 50s when they swap and still use the 260 gearbox.
      :: PNW Crew ::
      '87 325 4dr, '74 2002

      Comment


        #4
        i know that an e30 228mm clutch will fit a lightened s50 flywheel.

        the s50 flywheel is like $20 cheaper than an m42 flywheel.
        IG: deniso_nsi Leave me feedback here

        Comment


          #5
          the m3 clutch wont fit in the e30 m42 tanny. thats all i know. Im using a lightweight m20 jb flywheel with 325 disk and e30 m3 pressure plate

          Comment


            #6
            Originally posted by e304me View Post
            the m3 clutch wont fit in the e30 m42 tanny. thats all i know. Im using a lightweight m20 jb flywheel with 325 disk and e30 m3 pressure plate
            I know of a few e36 318's using M3 flywheel and clutch setups. I was under the impression that it would work in the e30 as well.

            What did you have interference with?

            Comment


              #7
              with the e36 tranny yes, i have one of those, but already bought the flywheel.

              are you putting in an s50???
              Last edited by e304me; 01-13-2007, 05:17 PM.

              Comment


                #8
                Originally posted by e304me View Post
                with the e36 tranny yes, i have one of those, but already bought the flywheel.

                are you putting in an s50???
                nope. I'm building up an M42 but I figured I'd ask in this forum. I had the chance to get a JB flywheel for an S50 at a good price but I guess i'll just go with a single mass m20 wheel.

                Comment


                  #9
                  if you want to do the e36 tranny then do it. But the e30 m3 pressure plate should be good for way more then what you need. Plus the rotational mass in closer in.

                  Comment


                    #10
                    Originally posted by e304me View Post
                    with the e36 tranny yes, i have one of those, but already bought the flywheel.

                    are you putting in an s50???
                    Not all S50 alu flywheel/clutch combos fit in the 318 trans. Mine didn't. Had to swap to the e36 325 trans.

                    Comment

                    Working...
                    X