If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yes, you can use the single mass m20 flywheel with an m50/e36 tranny. You need to have the back of the flywheel machined down and you need to use the e30 starter.
Yes, you can use the single mass m20 flywheel with an m50/e36 tranny. You need to have the back of the flywheel machined down and you need to use the e30 starter.
-Erik
and don't forget the clutch slave cylinder
you'll havta use the cylinder from the m20 single mass setup
Comment