-
Last edited by dpgrand; 10-14-2008, 12:32 PM. -
Originally posted by dpgrand View Post
Don't know what you mean, but it should be done exactly as the photos indicate."Life is hard...it's a lot harder if you're stupid."
Tom
72 2002
87 327i
88 525i
88 535i
03 530i -
That doesn't help the 12 degree tilt, that is for clearance for the vibration dampener.
Turning it 90 degrees will only turn the actual lever on the vertical plane, I don't see how it will make getting into fifth gear any easier.
On another note, I had to trim my tunnel to get clearance with my Z4 3.0 lever, with the selector rod twisted ~5-8 degrees. The knob barely rubs the console in both reverse and fifth, so twisting it any more wouldn't have helped, as it would have just rubbed the console even more in reverse.Comment
-
now i am so confused....
so what do I need to do in order to get the 260 getrag into 5th? I've been told that the selector rod needs to be bent 10-12°....Comment
-
my zf tranny selector rod is rubbing onto my drive shaft.. i wonder if this could solve my issues...Comment
-
You do need to twist it 10 degrees, if using a stock shifter (according to general consensus). I did not find this to be the case with my Z4 shifter, because the fat part actually hits the tunnel opening.Originally posted by dpgrand View Post
Twisting in this case means literally twisting, not bending. Think Twizzlers. hahaComment
-
ooohhhhhhhh. so the end connecting rods on the selector rod will be 10° from parallel with each other? sorry it's wordy, I couldn't think of a better way to say it....Comment
-
Exactly.Comment
-
Just stick one end in a vise and twist the other end with a pair of channel locks and test fit it until you can get it into 5th gear. I got lucky on mine and got it right on the 1st try. It's really not that big of a deal.Comment
Comment