Well 12 hours and mounts don't line up

[hugh jass]

nice job cleaning the parts and your engine bay before install

[SamE30e]

Well it's in.. I just need to deal with these stupid rad hoses.

[SamE30e]

nice job cleaning the parts and your engine bay before install

Eat a dick.

[logger]

You get it?

[hugh jass]

You get it?

probably not. i predict he is trapped under his greasy car with his arm trapped between the subframe and motor mount arm.

[416stroker]

probably not. i predict he is trapped under his greasy car with his arm trapped between the subframe and motor mount arm.

[SamE30e]

probably not. i predict he is trapped under his greasy car with his arm trapped between the subframe and motor mount arm.

You wish I was trapped under my car on my stomach covered in grease, that way you could just lube your hand up, slap some on your hockey stick shaped cock and slide it into my ass..

And 2 posts above yours I stated that it's in and I have to deal with rad hoses.

[logger]

You wish I was trapped under my car on my stomach covered in grease, that way you could just lube your hand up, slap some on your hockey stick shaped cock and slide it into my ass..

And 2 posts above yours I stated that it's in and I have to deal with rad hoses.

OH snap! hockey dick!


You have your rad hoses figured out?

[SamE30e]

I used my M42 ones. The upper rad hoses from the M42 work, you just need to shorten them. And the lower left one attaches to that pipe that runs under the intake mani, the original one off the M42 works, you just need to shorten it also. I broke the coupler so I need to go get another one. Do yourself a a favor and put the engine in with out the intake manifold on, it makes hooking the heater hoses up so much easier.

[logger]

Ha I did.