rear driveshaft for auto and manual - same?

[jb02]

325ix rear driveshaft length

Can somebody post the length of the rear driveshaft for the 325ix? Also confirm that this is a 1 pieve shaft with no center support bearing?

Thx,

Jonathan

[Kershaw]

Flange to flange it's 37 7/8".

It's 1 piece, no CSB, with 1 u joint at the rear.

[jb02]

325ix Rear Driveshaft Length & Spec's

Thanks for the info.....just what I needed. Once I realized I hadn't extended the length fully, it matched up to your 37 7/8 spec. Hopefully this used replacement shaft fixes my violent driveline shake at +40 mph