New IX clicking noise

[spdracrm3]

So I lifted the car and pulled on the tire to test the wheel bearing and it seemed pretty solid. I only ask because whenever I turn left I get a small vibration and a humming noise. Also what would be the correct torque for the axle nut?

Sent from my RM-877_nam_att_205 using Tapatalk

youve just been luck so far i guess its really not good for the bearing ,the axle torque is 210 ft/lbs . as far as the vibration if you have the axle in the other side it could be causing wierd effects/noises as you drive/turn just a thought.

[CrazyPrime]

Ok thanks for the torque spec. I have both front axles in and whenever I turn left I get a humming and slight vibration. Could the bearing cause this even though the wheel doesn't wiggle?

Sent from my RM-877_nam_att_205 using Tapatalk

[spdracrm3]

might have a bad RF wheel bearing (doesnt have to be loose to be bad), when you turn left the load shifts putting extra side load on RF wheel brg and that might be the noise/humming ,could also be a rear bearing so be sure to check them all

[CrazyPrime]

Ok thanks I'll check them. Thanks for all the help I really appreciate it!

Sent from my RM-877_nam_att_205 using Tapatalk