If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
sandblast or wirewheel/sand until all traces of corrosion/pitting are gone
clean with a solvent such as Acetone
epoxy prime (or use regular primer alternatively)
paint
re-undercoat with new schutz or alternative.
It always helps to spray on a Corrosion Inhibiting Compound of some kind from time to time as well, like Fluid film or LPS 3
Comment