Yeah I have a set of SPI that have been around for ages too. I use them for roughing and sawing etc. That's fairly decent at 1" for a pair that's been knocked around for a minute, but the further you pull them, the more they tend to skew. So, a little trick is to zero them out near your mark and go from there. If you have a rear bearing, could always zero it out on that then measure the front to note the difference.
Announcement
Collapse
No announcement yet.
Front Wheel Bearing confusion
Collapse
X
-
Originally posted by The Dark Side of Will View PostI wouldn't expect to be able to pick up a 0.002" difference with calipers.
Comment
Comment