If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
with the other lip i just attached it with a bunch of screws up into the lip, worked well, but.... i'd like the splitter to re-enforce the next lip, so any suggestions on beefing it up? thanks,
I used self tapping phillips head screws but do to scraping and wear and tear a couple of them on the edge got stripped and filled with crap. so i bought some of the same screws but with hex bolts on the end. maybe that will work better?
Comment