If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hmm... well I want to do it somewhat correct, but I don't have a welder. There are a lot of holes, and I was thinking that welding might end up just warping the roof.
I got a fender roller now! LMK if you need me to roll your fenders or want to rent the tool from me locally.
Welding is going to be the only way to properly fix those. I imagine a just a little bit in each one will take care of it, by someone who is competent in welding.
Alright, I welded the holes. And I also welded in a plate for the antenna. There is a slight drop since the 2 surfaces aren't leveled. How would I go about filling that? I know I'm not supposed to just slap bondo on that. I need to put fiberglass?
What length should I use? Long hairs or short hairs?
I got a fender roller now! LMK if you need me to roll your fenders or want to rent the tool from me locally.
Comment