So since I have installed GC touring plates and had a wheel alignment, I have noticed that my drives side (AUS right hand drive) shock tower is bent. I asked for an extra -0.5 degrees of camber on the front over stock. So the left camber plates sits pretty much in the middle while the right is way off.
After inspecting the shock tower I noticed a very small tear between the tower and the battery tray, and the brace that runs between the engine and the tower is a little bent. Ill post picture tonight.
I want to know weather this kind of thing can be straightened out by a body shop. Obviously anything can be done with enough money. But I want to know how hard this is correct and what it would cost ruffly to correct.
Thanks guys
After inspecting the shock tower I noticed a very small tear between the tower and the battery tray, and the brace that runs between the engine and the tower is a little bent. Ill post picture tonight.
I want to know weather this kind of thing can be straightened out by a body shop. Obviously anything can be done with enough money. But I want to know how hard this is correct and what it would cost ruffly to correct.
Thanks guys
Comment