is skirt hardware question

[cahomey]

Ok I searched and didn't find much but does anyone know where # 12 and #11 go?

http://www.realoem.com/bmw/showparts...69&hg=51&fg=20

[golde30]

some1 who has installed these before chime in and help this ass-clown get his IS skirts on!!

[e30this]

They go on the pinch weld. its what holds the bottom of the skirt back tight.

[Kilawin]

I only used #9 the bottom clips. I didn't want to drill holes in the rocker so I used 3m double stick tape in place of #11.

[golde30]

I only used #9 the bottom clips. I didn't want to drill holes in the rocker so I used 3m double stick tape in place of #11.

yah thats the same advice i gave. i used 3m for my side skirts as well.

[monty]

yah thats the same advice i gave. i used 3m for my side skirts as well.

Thats just lazy.:) #11 goes on the end of the skirt between the rear wheel and wheel lip. You need to drill 2 holes in the wheel lip on both sides. #12 is used for the small piece of skirt that goes on the fender. It clips on the inside of the skirt piece. You need to drill a hole in the fender, then the stud on the clip goes through the fender and you put the supplied nut (if you got them) on the inside of the fender.