If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Not sure I'm going to sell it yet. If I do, I'll pm you but I suspect I'll be looking to make something off of it so I can pay for all the other important things I need. The idiot I bought it from had it listed under ignitions so nobody ever found it. I'll be fair if I sell.
I think the BMP rear wing, that one, is ugly as sin.
After looking at what you have on your car, I think the one I have may look closer to lines of the e30. Yours looks good, but it borders on clashing with the car's natural lines. I'd prefer an M3 wing but this is a bit lower, less obtuse, and seems to fit the lines better. What else did you consider?
THIS IS ABSOLUTELY NOT A HARTGE WING!!!!! If is was an early schnitzer wing it would have the id molded in. It could be the bmpd early schnit copy, a zender, a foha, or some other style m3 copy. Once again, IT IS NOT A HARTGE!!!! There is no step in the transition from wingblade to upright on a hartge, and the hartge goes to the edge of the deck not just the deck lid.
w
Comment