Hi. Would this seat fit?

[jaywood]

'90 325i sedan.

If I made some custom brackets && what not, would this seat fit?

[Wishno87]

IIRC the width is pretty snug but it should fit.

[coreyw]

You don't have a tape measure?

It'd be a lot quicker than waiting for a reply here. Ignore this if there's a valid reason for asking though.

[HippyEarly]

Mine are

H- 21 3/4

D- 20 1/4

My lower bolsters D rub on my center console. At another 3/4 inch its going to rub a little harder (especially if your short aka you need the seat far forward).

At the shoulder wings aka H, It is difficult to pull the seat belt from behind the seat but not impossible.

I think they would fit but they will be snug. I would definitely not say "don't run them". I think they will work.

I can up a pic of mine tomorrow if you want visuals.

[jaywood]

It's dark out and I don't have easy light access. I just wanted to get a feel for what would fit.

Visuals would be a big plus

Thanks for the help so far ;)

[Nick325is]

I don't have any really good pics of my old seats installed. They were Corbeau A4s and were very similar in shape to these. The base of mine were two inches narrower than yours and I was very close to rubbing on the center console. The top of the seat should be a snug fit, but I'm not sure the bottom will clear.

[a2coupe2a]

It either is, or is based off of a Recaro Speed which is based off the SRD, which came stock in the evo m3's..

[a2coupe2a]

btw if its a knock off stay away unless you want to pretty much have the seat explode in a car accident