my one friend has 318is with 8 giant cracks going from the bottom of the windshield towards the cabin. it looks like death valley.
on the other had, both of my 325i's have pristine dashes.
methods for stopping/ repairing dash cracks
Collapse
X
-
Drilling holes didn't do anything for me - it worked it's way past them eventually (plus they still looked like damnit).
So then I replaced it with a non-cracked used dash, and that cracked a few months later and looked 3x worse than the original.Leave a comment:
-
and a new dash cost >400 dollars and a non cracked one is uber rareLeave a comment:
-
-
Replacing the dash isn't TOO hard....you could go that route too.Leave a comment:
-
my dash isnt cracked either. so if ou dont mind the look, put a nice dash cover on there. it will help a lot.Leave a comment:
-
Drill a small hole where the crack terminates and it won't spread.
That's the only thing I can think of, my dash isn't cracked!Leave a comment:
-
methods for stopping/ repairing dash cracks
what are they, are there any, i know some people drill holes at the ends of the crack to stop them and im sure it works but i dont think that would look much better than a crack.
ive developed a small (~3/4 in) crack on the corner closest to the driver of that storage bit on the pass side.
edit:i consider myself luck cause you can just barely see it cause most of it is on the down slope into the trayTags: None

Leave a comment: