methods for stopping/ repairing dash cracks

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • silversleeper
    replied
    my one friend has 318is with 8 giant cracks going from the bottom of the windshield towards the cabin. it looks like death valley.

    on the other had, both of my 325i's have pristine dashes.

    Leave a comment:


  • Bill 84 318i
    replied
    Drilling holes didn't do anything for me - it worked it's way past them eventually (plus they still looked like damnit).

    So then I replaced it with a non-cracked used dash, and that cracked a few months later and looked 3x worse than the original.

    Leave a comment:


  • NC325iC
    replied
    and a new dash cost >400 dollars and a non cracked one is uber rare

    Leave a comment:


  • MikeE30325i
    replied
    Originally posted by ZinRot325i
    Replacing the dash isn't TOO hard....you could go that route too.

    yeah, though the speedo and center area is always a bitch.

    Leave a comment:


  • ZinRot325i
    replied
    Replacing the dash isn't TOO hard....you could go that route too.

    Leave a comment:


  • MikeE30325i
    replied
    my dash isnt cracked either. so if ou dont mind the look, put a nice dash cover on there. it will help a lot.

    Leave a comment:


  • ZinRot325i
    replied
    Drill a small hole where the crack terminates and it won't spread.

    That's the only thing I can think of, my dash isn't cracked!

    Leave a comment:


  • NC325iC
    replied
    hey look at that noone responded

    Leave a comment:


  • NC325iC
    started a topic methods for stopping/ repairing dash cracks

    methods for stopping/ repairing dash cracks

    what are they, are there any, i know some people drill holes at the ends of the crack to stop them and im sure it works but i dont think that would look much better than a crack.

    ive developed a small (~3/4 in) crack on the corner closest to the driver of that storage bit on the pass side.
    edit:i consider myself luck cause you can just barely see it cause most of it is on the down slope into the tray
Working...