hi all, i tried searching for this but was unable to find a diy thread (though i thought one already existed for it). is there a write up out there regarding how to not have the low beams auto-turn off when the high beams are on?
(it is annoying because if i have my high beams on for an extended period of time, and then i switch back to my low beams, the ballasts for my hids need to warm up again so i essentially have to pull over for 30 seconds or drive without lights.)
thanks,
aurash
(it is annoying because if i have my high beams on for an extended period of time, and then i switch back to my low beams, the ballasts for my hids need to warm up again so i essentially have to pull over for 30 seconds or drive without lights.)
thanks,
aurash
Comment