Help? Check Brakes Light

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ZM Blue Devil
    Forum Sponsor
    • Dec 2006
    • 13836

    #1

    Help? Check Brakes Light

    Bulbs - checked/replaced
    Brake sensor switched - checked
    overhead panel - replaced
    tail light back covers - replaced

    The initial check brake light on the overhead panel will not go off unless the reset button is pressed on.

    All the lights works, tried the above things, no help.

    Anyone have this happen before?

    What am I missing?

    L
    sigpic
    New website releasing soon www.gutenparts.com Guten Parts + Service | Facebook | Twitter
    ____________________________________

    Levent
    %20levent@gutenparts.com

    ____________________________________
    Ladies:
    1998 E36 m3/4/5 1988 325i 1989 325iT
  • lga714
    Grease Monkey
    • Feb 2010
    • 315

    #2
    Isn't this a common E30 problem?

    mtechII 5 lug S50

    Comment

    • jasonsnoddy
      E30 Mastermind
      • Feb 2010
      • 1900

      #3
      mine always does this


      Originally posted by stewie30luvr
      ooo cause i was fixing my chain tensioner and there was a black widow on the radiator so i killed it
      Originally posted by JakeP
      with a coathanger

      Comment

      • unrlmth
        E30 Addict
        • May 2010
        • 467

        #4
        Mine turns on when I start the car and then goes off when I first tap the brakes.
        1989 325i Alpineweiß II

        Comment

        • ZM Blue Devil
          Forum Sponsor
          • Dec 2006
          • 13836

          #5
          Originally posted by unrlmth
          Mine turns on when I start the car and then goes off when I first tap the brakes.
          Yes that's what's suppose to happen.

          On this particular e30 after you tap brakes it doesn't turn off. Hence my request for help.
          sigpic
          New website releasing soon www.gutenparts.com Guten Parts + Service | Facebook | Twitter
          ____________________________________

          Levent
          %20levent@gutenparts.com

          ____________________________________
          Ladies:
          1998 E36 m3/4/5 1988 325i 1989 325iT

          Comment

          • dashboardmonkey
            FUCK YOUR WAFFLES
            • Jun 2008
            • 6158

            #6
            my old 84 had this same problem....

            good luck
            -Andy

            Comment

            • kronus
              R3V OG
              • Apr 2008
              • 13000

              #7
              Levent, there is a brake check relay inside the trunk, on the left, behind the carped, bolted to a body support near the antenna. Take it out, replace with a known good one, see if the behavior changes.
              cars beep boop

              Comment

              • Zasz
                E30 Enthusiast
                • Sep 2010
                • 1030

                #8
                I don't really mind tapping my brakes when I start my car, but is there a way to get rid of the "Check Brakes" light on overhead display?
                ///Z

                1988 BMW 325 Super Eta - Elsa

                "i"CONVERSIONWARchip&3.0MAF3.73LSDBBSRSsSMILIES"is"SPOILER+LIPHOUNDSTOOTHSHORTSHIFTERPLASTICBUMPERCONVERSIONEtc.



                Sell Me Your SCHWARZ FENDERS!

                Originally posted by chadthestampede
                ^ Nothing you post makes any sense.

                Comment

                • DaveSmed
                  E30 Fanatic
                  • Apr 2007
                  • 1406

                  #9
                  Super simple circuit. It's a bunch of relays with the switched contacts wired in series. So the left brake light, right brake light, and CHMSL relay contacts all need to close in order to provide a ground (through a current limiting resistor) to the check panel.

                  What I would do is turn the key on, and wedge something in between the brake pedal and the seat. Now check control is expecting a ground signal to indicate the brake lights are ok.

                  Not sure if we are talking early or late, but depending on which chassis you have, locate the CHMSL check relay. It will have four wires going to it, incl. two green/black wires. unplug it, and make a jumper to connect a green/black wire to ground. Did the brake fault light go out? If not try the other green/black wire. (its terminal 3 btw)

                  If the check light never went out, you have a wiring fault between the CHMSL check relay and check panel. If it did go out, regenerate the fault in check control, and jump the green/black wires together. Does the fault re-clear? If so, CHMSL problems. If not, rear brake light/check relay problems.
                  -Dave
                  2003 Lincoln Towncar | 1992 BMW 325iC | 1968 Cadillac Deville

                  Need some help figuring out the ETM?

                  Comment

                  • Zasz
                    E30 Enthusiast
                    • Sep 2010
                    • 1030

                    #10
                    Originally posted by DaveSmed
                    Super simple circuit. It's a bunch of relays with the switched contacts wired in series. So the left brake light, right brake light, and CHMSL relay contacts all need to close in order to provide a ground (through a current limiting resistor) to the check panel.

                    What I would do is turn the key on, and wedge something in between the brake pedal and the seat. Now check control is expecting a ground signal to indicate the brake lights are ok.

                    Not sure if we are talking early or late, but depending on which chassis you have, locate the CHMSL check relay. It will have four wires going to it, incl. two green/black wires. unplug it, and make a jumper to connect a green/black wire to ground. Did the brake fault light go out? If not try the other green/black wire. (its terminal 3 btw)

                    If the check light never went out, you have a wiring fault between the CHMSL check relay and check panel. If it did go out, regenerate the fault in check control, and jump the green/black wires together. Does the fault re-clear? If so, CHMSL problems. If not, rear brake light/check relay problems.
                    Thanks a bunch. Would that prevent me from knowing when my brake lights are actually out?
                    ///Z

                    1988 BMW 325 Super Eta - Elsa

                    "i"CONVERSIONWARchip&3.0MAF3.73LSDBBSRSsSMILIES"is"SPOILER+LIPHOUNDSTOOTHSHORTSHIFTERPLASTICBUMPERCONVERSIONEtc.



                    Sell Me Your SCHWARZ FENDERS!

                    Originally posted by chadthestampede
                    ^ Nothing you post makes any sense.

                    Comment

                    • DaveSmed
                      E30 Fanatic
                      • Apr 2007
                      • 1406

                      #11
                      Originally posted by Zasz
                      Thanks a bunch. Would that prevent me from knowing when my brake lights are actually out?

                      Yes sir!
                      -Dave
                      2003 Lincoln Towncar | 1992 BMW 325iC | 1968 Cadillac Deville

                      Need some help figuring out the ETM?

                      Comment

                      • iwantspeed
                        No R3VLimiter
                        • Dec 2007
                        • 3164

                        #12
                        was the brake switch at the actual pedal replaced?

                        the wire harness for that plug is pathetic.


                        -
                        Project
                        Parts for Sale
                        Feedback
                        YouTube Channel

                        Comment

                        • worangejuice
                          E30 Mastermind
                          • Jun 2009
                          • 1837

                          #13
                          This stupid light is the only reason cops can still pull me over for no good reason >:(

                          www.woranges.tumblr.com

                          Comment

                          • DaveSmed
                            E30 Fanatic
                            • Apr 2007
                            • 1406

                            #14
                            You get pulled over because a red LED on your overhead panel is on?
                            -Dave
                            2003 Lincoln Towncar | 1992 BMW 325iC | 1968 Cadillac Deville

                            Need some help figuring out the ETM?

                            Comment

                            • worangejuice
                              E30 Mastermind
                              • Jun 2009
                              • 1837

                              #15
                              Originally posted by DaveSmed
                              You get pulled over because a red LED on your overhead panel is on?
                              haha, no, smartass ;) the back rear window tail light, or I've been told by the policia that its one of my taillights. But I assume its the 3rd rear window one, cause it intermittently works

                              www.woranges.tumblr.com

                              Comment

                              Working...