If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Bump, just did this the other day, I used the heat gun slightly differently than this DIY, only used it on the curved edges, and just peeled back the backing about an inch or two at a time as I went, pushing it down in one direction to avoid bubbles.
Anyway, thanks to your suggestions it came out great, here's a picture with only the left done. I love the way it looks.
I purchased the vinyl from rvinyl on ebay, was about $8 for a 12*48" roll.
I painted mine, but the finish product on this is really good. I think the idea that if you really get bored of them im sure you can peel it back off or even change the look by cutting the reverse and having all reds with the white reverse. Thanx for the DIY good job.
Leave a comment: