Replacing fog light lenses

[Beastolizer]

I searched and couldn't find any threads on how to remove the old lenses and replace them with new ones. If I missed the thread, please direct me to it, if not, how are people removing the old glass lenses and putting the new ones on?

Thanks!
-Parker

[redhatpat]

Original ones are held on with glue, just cut off the old lenses. I used clear silicone to hold on the replacement lenses and it's been fine for 3 years so far.

[Beastolizer]

already tried that. the lenses are pretty tight on the frame, not really anywhere to cut at.

[Beastolizer]

iiiiiii neeeeeeddd help on this. trying to get this done today

[Balleristic31]

I literally just busted mine and used a pair of pliers to pull the old broken glass off.

[Beastolizer]

I literally just busted mine and used a pair of pliers to pull the old broken glass off.

might just end up doing that if there isnt a better way to get the lenses off

[aworthybrother]

I literally just busted mine and used a pair of pliers to pull the old broken glass off.

I did the same thing...

I followed this thread for changing my lenses...

http://www.r3vlimited.com/board/showthread.php?t=137656

[Simon S]

I literally just busted mine and used a pair of pliers to pull the old broken glass off.

ditto

[Beastolizer]

looks like im going that route now

[bernzpeed]

yeah that's what i did too. clean it off with a little heat gun and wiping it away.

[cncmastr]

Where does one acquire the replacement glass?

[cncmastr]

I think I found some on here:

http://www.pelicanparts.com/cgi-bin/...FILTER_TOOL=ON

[lbreevesii]

Only place I know of is via bmwlights(see link in diy thread). They're polycarb.

Heres mine. I painted the projector holder and did a few other subtle internal mods. eg: the end bits of the lens that stick out past the housing are smoked on OE's, replacements aren't. So I painted those too.