Announcement

Collapse
No announcement yet.

Stumped: Where to install Alpine KTP-445 power pack?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Stumped: Where to install Alpine KTP-445 power pack?

    Hi Guys,

    Surely someone here must be running one of Alpine's power pack amps. I cannot figure out a good place to mount it though, any suggestions?

    This is what I'm referring to: http://www.alpine-usa.com/product/view/ktp-445

    Thanks in advance!

    1987 325e - 5 speed - Mods: 3.25 LSD, Mark D Chip, Bilstein HD's, Ansa Sport

    #2
    Theres better ways to boost your power.. but why not just put it by your amp??

    Comment


      #3
      I installed mine inside the center console it fits perfectly. You will have to pull your amp wires past the shifter and connect.
      the amps connector to the HU. then run other end of your wires under the carpet and to the back seat where it meets bypassed stock amp wiring under the seat.

      works fine now.

      just enough power
      Last edited by bmwfan52; 09-22-2020, 08:40 PM.

      Comment


        #4
        I've installed similar tiny amps below the dimmer/headlight switch, up in the drivers side dash.
        Owner - Bavarian Restoration
        BMW and European Electronics Repair and Restoration
        www.BavRest.com
        My Feedback Thread
        Our Facebook!
        Follow our Instagram!

        Comment

        Working...
        X