I picked up a pair of sail panel tweeters and am going to be installing my whole stereo system in the next week. I've located the wires behind the speakers to connect them up but I'm not sure where on my speaker to connect them? Using some Polk 5 1/4 two ways that have a small resistor going to the tweeter but I'm wanting to wire in the sail panel tweeters to these. Here's what I'm looking at...
Intially I was going to be using my Polk/Momo two ways with an outboard crossover and was simply going to wire them into that, easy enough. The right side fits in perfect to the stock location strangely enough (it's a 6 1/2) but the left side doesn't fit due to all the wiring so I've opted to put those in the rear...also since my Polk/Momo components won't fit anywhere without cutting. My other thought was simply run wires to the rear to the crossovers anyways?
The rears will be ran off my Alpine 4ch amp and the sub will be bridged off channels 3 and 4. Ran this same setup in my focus with great results. The fronts will be run off the headunit. I'm somewhat of an audio newb but I know enough to set it up. Any help is appreciated though, hope I didn't confuse anyone.
Here's everything I was hoping to use
Again though, the components won't fit anywhere so I'm leaving them out in favor of my regular Polk 5 1/4's.
Intially I was going to be using my Polk/Momo two ways with an outboard crossover and was simply going to wire them into that, easy enough. The right side fits in perfect to the stock location strangely enough (it's a 6 1/2) but the left side doesn't fit due to all the wiring so I've opted to put those in the rear...also since my Polk/Momo components won't fit anywhere without cutting. My other thought was simply run wires to the rear to the crossovers anyways?
The rears will be ran off my Alpine 4ch amp and the sub will be bridged off channels 3 and 4. Ran this same setup in my focus with great results. The fronts will be run off the headunit. I'm somewhat of an audio newb but I know enough to set it up. Any help is appreciated though, hope I didn't confuse anyone.
Here's everything I was hoping to use
Again though, the components won't fit anywhere so I'm leaving them out in favor of my regular Polk 5 1/4's.
Comment