So installed prem tweets into my 318i ft doors. I just read that they need a x-over so as not to blow up. I was just going to use the stock 5 1/4 mids in the kicks but there are no caps or anything there other than the speaker. The combined 8 ohm loads in parallel basically equal 4 ohms so the deck should be pretty happy running that. but I need to know: What do I buy to save the tweets? Is it installed in parallel or in series? Would Radio Shack have what i need? Is there anything cheap I could use to cut the high frequencies for the mid?
My deck will cut the low bass out to save the mids at approx 120Hz or so.
I'm using a kenwood 50w x 4 mediocre deck to power eveything.
I am just trying to maximize the components that I already have and get a little better sound quality.
I have searched and found some info but not exactly what i need so any help would be much appreciated
My deck will cut the low bass out to save the mids at approx 120Hz or so.
I'm using a kenwood 50w x 4 mediocre deck to power eveything.
I am just trying to maximize the components that I already have and get a little better sound quality.
I have searched and found some info but not exactly what i need so any help would be much appreciated
Comment