Creative sub level control install

[randomtask37]

Anyone have a creative subwoofer level control install location?

Sent from my ADR6400L using Tapatalk 2

[ACS Cabrio]

Anyone have a creative subwoofer level control install location?

Sent from my ADR6400L using Tapatalk 2

i used one of the climate control blanks

ill shoot you a pic when i get a chance

[StereoInstaller1]

http://www.r3vlimited.com/board/showthread.php?t=209700

[DRTSRFR]

I did mine similar to Lukes mod.

...but then installed a pop-out head unit which blocked the knob.

So I made a little bezel out of a chunk of aluminum and gave this location a shot.

...still working on the finish, but you get the idea.

[CorvallisBMW]

I put mine in a blank tile next to the hazard switch

[Cabriolet]

why? most HU come with bass control one tap in. have an extra nob around just doesn't make sense.

[DRTSRFR]

Engrish?

Did you get all your stuff installed?

...and most head units have a basic level control but no way to boost the lower frequencies of the sub signal.

[Cabriolet]

ya i typed that as my boss was coming so didn't prof.
not fully yet. ill finish it next weekend.
all my alpine headunits have had sub control and it is supper easy access. just tap the dial once and its at the sub lvl.

[randomtask37]

I posted what I did with mine at the end of the 500 dollar stereo sticky thread

Sent from my ADR6400L using Tapatalk 2

[DRTSRFR]

Hmmm...

From my experience the sub control on most head units boost the entire sub signal. My amp controller lets me boost only 63hz and below. I do my best not to make changes at the head unit unless absolutely necessary.

I was running the box cut at 125hz when I had the stock premiums in there, but I just installed 6.5s which allowed me to cut the box in the 80s...much better. Now the box POUNDS without having to produce all of the higher fill frequencies. Particularly with the hardtop on...DUH.

Staging is far superior too.

[future rs]

The stock speaker/fader control knob is a potentiometer correct? I wonder what the specs on it are. I bet you could wire up the sub control to that knob and then it would be 100% factory looking.

[DRTSRFR]

It can be done. we did it to a 190 Cosworth we have here at the shop.

[AlphaE]

The stock speaker/fader control knob is a potentiometer correct? I wonder what the specs on it are. I bet you could wire up the sub control to that knob and then it would be 100% factory looking.

THIS^^ any one do it??? im gonna give it a go. Gotta check the controller.. Can i solder in RCA jacks to the controller and then run it from my "rear" output (crappy HU but matches car) to the controller/fader and then the rca to my amp??