Passive and Active Crossovers, EQ's etc...

[kylebes1]

Who has them and which ones do you like the most.

[StereoInstaller1]

Fuckabunchof passive crossovers.

Audiocontrol FTW!

Luke

[marakka]

Thats what I was gonna say ^^^^^


Audiocontrol will never let you down.

[kylebes1]

Well that is what I have already.

EQS with a 4XS to seperate mids and tweeter signal. I have to get another AMP though. Actually two more.

I suppose I will end up with two four channel amps- 4 tweeters and 4 midbass and 1 mono amp for the sealed cabin sub.

I may end up with another amp and add a rear facing ported sub... since the sound of a sealed sub and a ported sub are so different.

-Kyle

[marakka]

Do you have 2 separate mid sets and 2 separate tweeter sets or do you have 2 component sets?

[StereoInstaller1]

Well that is what I have already.

EQS with a 4XS to seperate mids and tweeter signal. I have to get another AMP though. Actually two more.

I suppose I will end up with two four channel amps- 4 tweeters and 4 midbass and 1 mono amp for the sealed cabin sub.

I may end up with another amp and add a rear facing ported sub... since the sound of a sealed sub and a ported sub are so different.

-Kyle

Kyle, since you are using a EQs, you don't have a fader or sub control?

Go to 6XS, you get a sub level knob for your dash, front is tri-amped, rear is bi-amped, has 3 sets of inputs.

To use wide band EQ you would need either 3 EQs', or a different EQ.

If you go to DQXS, you get basically 3 of your EQ, PLUS all of the features of a 6XS...http://mobileaudiocontrol.com/produc...7&l1=5247&l2=#

Then you could add a DDC http://mobileaudiocontrol.com/produc...47&l1=5247&l2=

Then you could completely fuck up the sound quality of your bass by adding a second subwoofer, and worse still, make it ported!

Luke

[kylebes1]

Ok, forget the second sub then

My headunit has six preamp outputs. Stereo Front, Rear and sub.

I have two mids up front and two tweeters up front and the same setup for the rear.

Thanks Luke, I wish I were closer so you could help me in person. I like doing stuff on my own, and with enough reading of owner's manuals I am figureing it all out.