Need help installing keyless entry!

[akwon]

Just bought this from eBay, but can't figure out the install. I have researched a lot and the procedure looks very simple (using wires in trunk for lock/unlock...looks super easy)

I have the LOCK function working by connecting the green wire on the alarm (negative power window output), but cannot figure out UNLOCK. The chart they provided doesn't shed much detail. I have also tested each wire with the trunk's UNLOCK wire to no avail.

WIRE DIAGRAMS:

http://screencast.com/t/K3By8fIj079O

http://screencast.com/t/SI9r5cDpXLcB

[Cosmic Serpent]

For my cheep ebay keyless entry I used the negative trigger diagram if i recall correctly. The issue that you may be running in to is that if the kit is like mine the car needs to be locked via the keyless entry 1st before the unlock feature can be used.
hope this helps

[AndrewBird]

Looking at this diagram:

http://screencast.com/t/SI9r5cDpXLcB

You want to use the "Negative Trigger" diagram. The unlock wire is the very bottom one. Connect this to the Green/Purple wire in the car.

[akwon]

I'll give that a shot. Right now, the bottom wire activates unlock.

Sent from my SGH-M919 using Tapatalk

[StereoInstaller1]

No, that chintzy pile of crap has a garbage manual, the lines are not lined up.

I bet that bottom wire is ground, then the diagram makes sense.

See if those hacks used the words "NC" or NO" (Normally Closed or Normally Open) or "30" "87" or "87a" anywhere in that ESL manual in relation to the locks.

What you should have is 2 wires to ground and 2 wires to the car.

[AndrewBird]

Oh wow, that is bad. Didn't even notice. Bottom wire is ground, the wire above it should be unlock.

[ecsk]

These eBay CL kit all come out from same factory, their wiring are all the same

orange pair - cut out
white pair - lock/unlock
yellow pair - connect to +ve for positive trigger, connect to ground for negative trigger

Just refer to the positive trigger wiring diagrame, instead of connect to +ve, connect them to ground.

[akwon]

These eBay CL kit all come out from same factory, their wiring are all the same

orange pair - cut out
white pair - lock/unlock
yellow pair - connect to +ve for positive trigger, connect to ground for negative trigger

Just refer to the positive trigger wiring diagrame, instead of connect to +ve, connect them to ground.

Oh boy, if this works, I'll be so happy. Thank you!

Sent from my SGH-M919 using Tapatalk

[TSI]

I used one of those. Be careful using two transmitters, as if you lock with one and don't unlock it, the other transmitter will be reversed!

[akwon]

I used one of those. Be careful using two transmitters, as if you lock with one and don't unlock it, the other transmitter will be reversed!

Is there a way you could take a picture of his you wired it?

Sent from my SGH-M919 using Tapatalk

[TSI]

Is there a way you could take a picture of his you wired it?

Sent from my SGH-M919 using Tapatalk

Sure, my gf has the car right now and is gone until Tuesday, but I can do it then.

[akwon]

Sure, my gf has the car right now and is gone until Tuesday, but I can do it then.

Hey,

Any chance you had a chance to do this? I would really appreciate it!

[meddle]

Oh boy, if this works, I'll be so happy. Thank you!

Sent from my SGH-M919 using Tapatalk

It worked for me thank you very very much!:pimp:

[akwon]

Followed the instructions and it all works except unlock. Maybe my device is defected.